Configuring your Email Client

When configuring your e-mail program, you'll need to enter the following data:

  • Incoming (POP) server: mail.yourdomain.com or yourdomain.com
  • Outgoing (SMTP) server: You may use either your ISP SMTP mail server, or mail.yourdomain.com. Both will require authentication.
  • POP account or username: this is the name of the mail account. THE ENTIRE EMAIL ADDRESS IS REQUIRED FOR THE USER NAME
  • Password: the password you chose or were given when setting up your email account.
You can also read your email online, either through the button on your control panel or by going to www.yourdomain.com/webmail.  Enter your email user name and password.

Was this answer helpful?

 Print this Article

Also Read

Someone is using my email address to send SPAM

More likely, someone is simply "spoofing" your email address.� It's simple to...

I keep receiving the same messages over and over. The program says receiving message 11 of 12 and then stops. When I try again, I keep getting the same messages.

This is related to the same issue described above. Outlook does not tell the mail server which...

Using Outlook To Send Autoresponders

You will need to leave your computer on, Outlook open, and hi-speed connection on while you are...

My email won't send!

You should, whenever possible, be using your ISP as the outgoing mail server. Most high speed...

My Outlook program "freezes" every time I try to receive mail. It says receiving message 11 of 12 (for example) and stops at the same place every time.

Chances are that the Outlook program is still working fine. We've seen this several times lately...

Powered by WHMCompleteSolution